User manual
Table Of Contents
- Contents
- Important information
- Chapter 1: About your interactive whiteboard system
- Chapter 2: Installing your interactive whiteboard system
- Chapter 3: Using your interactive whiteboard system
- Appendix 4: Integrating other devices
- Chapter 5: Maintaining your interactive whiteboard system
- Chapter 6: Troubleshooting your interactive whiteboard system
- Before you start
- Determining your interactive whiteboard system’s status
- Resolving interactive whiteboard issues
- Resolving projector issues
- Resolving ECP issues
- Accessing the service menu
- Transporting your interactive whiteboard system
- Appendix A: Remotely managing your system through a network interface
- Appendix B: Remotely managing your system through an RS-232 serial interface
- Connecting your room control system to the ECP
- Projector programming commands
- Appendix C: Remote control code definitions
- Appendix D: Hardware environmental compliance
- Index
Appendix B
67 smarttech.com/kb/170401
Appendix B: Remotely managing your system
through an RS-232 serial
interface
Connecting your room control system to the ECP 68
Serial interface settings 68
Projector programming commands 69
Projector power state controls 69
Command\response definitions 69
Field definitions 70
Source Application Selection 70
Command\response definitions 70
Field definitions 71
Video Control 72
Command\response definitions 73
Field definitions 74
Audio Control 78
Command/response definitions 78
Field definitions 79
Command/response definitions 81
Field definitions 81
Command/response definitions 83
Field definitions 85
Command/response definitions 90
Field Definitions 91
Command/response definitions 93
Field definitions 93
Command/response definitions 95
This appendix includes detailed instructions on how to set up your computer or room control system
to remotely manage your SMARTBoard800i6 interactive whiteboard system settings through an
RS-232 serial interface.