User manual
Table Of Contents
- Contents
- Important information
- Chapter 1: About your interactive whiteboard system
- Chapter 2: Installing your interactive whiteboard system
- Chapter 3: Using your interactive whiteboard system
- Appendix 4: Integrating other devices
- Chapter 5: Maintaining your interactive whiteboard system
- Chapter 6: Troubleshooting your interactive whiteboard system
- Before you start
- Determining your interactive whiteboard system’s status
- Resolving interactive whiteboard issues
- Resolving projector issues
- Resolving ECP issues
- Accessing the service menu
- Transporting your interactive whiteboard system
- Appendix A: Remotely managing your system through a network interface
- Appendix B: Remotely managing your system through an RS-232 serial interface
- Connecting your room control system to the ECP
- Projector programming commands
- Appendix C: Remote control code definitions
- Appendix D: Hardware environmental compliance
- Index
C H A P T E R 4
Integrating other devices
34 smarttech.com/kb/170401
To connect a DVD/Blu-ray player or similar device
1. If you have speakers installed, turn the volume dial on the ECP all the way down to prevent
buzzing or popping.
2. Press the Input button on the ECP or remote control to switch input sources to the peripheral
device.
3. Restore the volume on the ECP’s volume dial.
N O T E
HDMI inputs are High Definition Content Protection (HDCP) compliant.