User manual
Table Of Contents
- Contents
- Important information
- Chapter 1: About your interactive whiteboard system
- Chapter 2: Installing your interactive whiteboard system
- Chapter 3: Using your interactive whiteboard system
- Appendix 4: Integrating other devices
- Chapter 5: Maintaining your interactive whiteboard system
- Chapter 6: Troubleshooting your interactive whiteboard system
- Before you start
- Determining your interactive whiteboard system’s status
- Resolving interactive whiteboard issues
- Resolving projector issues
- Resolving ECP issues
- Accessing the service menu
- Transporting your interactive whiteboard system
- Appendix A: Remotely managing your system through a network interface
- Appendix B: Remotely managing your system through an RS-232 serial interface
- Connecting your room control system to the ECP
- Projector programming commands
- Appendix C: Remote control code definitions
- Appendix D: Hardware environmental compliance
- Index
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
95 smarttech.com/kb/170401
Additional commands
These commands & behaviors are to provide backward compatibility for legacy control interfaces.
Command/response definitions
Command Execute command: Behaviour
set input=VGA1 set input=VGA1 switch to VGA1 port
set input=HDMI set input=NEXT switch to next physical port
set input=Composite set input=NEXT switch to next physical port
set input=S-video set input=NEXT switch to next physical port
set input=VGA2 set input=NEXT switch to next physical port