User manual
Table Of Contents
- Contents
- Important information
- Chapter 1: About your interactive whiteboard system
- Chapter 2: Installing your interactive whiteboard system
- Chapter 3: Using your interactive whiteboard system
- Appendix 4: Integrating other devices
- Chapter 5: Maintaining your interactive whiteboard system
- Chapter 6: Troubleshooting your interactive whiteboard system
- Before you start
- Determining your interactive whiteboard system’s status
- Resolving interactive whiteboard issues
- Resolving projector issues
- Resolving ECP issues
- Accessing the service menu
- Transporting your interactive whiteboard system
- Appendix A: Remotely managing your system through a network interface
- Appendix B: Remotely managing your system through an RS-232 serial interface
- Connecting your room control system to the ECP
- Projector programming commands
- Appendix C: Remote control code definitions
- Appendix D: Hardware environmental compliance
- Index
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
93 smarttech.com/kb/170401
Engineering commands
These commands are to be part of the RS232 list but not viewable by the “?” command
Command/response definitions
Command Response Powered off
set dbmsgon [target] dbmsgon =[current] no
get vgacalibration vgacalibration =
[current]
no
get waveformid waveformid=[current] no
get lampvoltage lampvoltage =[current] no
get temperature temperature =[current] no
set temperaturereport
[target]
temperaturereport=
[current]
no
set
downloadlampdriver
[target]
downloadlampdriver=
[current]
no
clearfailurelog no
set burnin no
dwscaler#7537 no
Field definitions
Field Possible Values Description
target dbmsg l on
l off
Turn on/off debug message.
current vgacalibration l ??? To get the status of ADC calibration while power
on.
current waveformid l ??? To get waveform ID while power on.
current lampvoltage l ??? To get lamp voltage while power on.