User manual
Table Of Contents
- Contents
- Important information
- Chapter 1: About your interactive whiteboard system
- Chapter 2: Installing your interactive whiteboard system
- Chapter 3: Using your interactive whiteboard system
- Appendix 4: Integrating other devices
- Chapter 5: Maintaining your interactive whiteboard system
- Chapter 6: Troubleshooting your interactive whiteboard system
- Before you start
- Determining your interactive whiteboard system’s status
- Resolving interactive whiteboard issues
- Resolving projector issues
- Resolving ECP issues
- Accessing the service menu
- Transporting your interactive whiteboard system
- Appendix A: Remotely managing your system through a network interface
- Appendix B: Remotely managing your system through an RS-232 serial interface
- Connecting your room control system to the ECP
- Projector programming commands
- Appendix C: Remote control code definitions
- Appendix D: Hardware environmental compliance
- Index
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
92 smarttech.com/kb/170401
Field Possible Values Description
current factoryreset l = true
l = false
Set to true only if a factor reset is about to occur.
target highspeedfan l = high
l = normal
The ranges must match the OSD ranges
current highspeedfan l high
l normal
The ranges must match the OSD ranges
current statereporting l on
l off
Current state reporting value
target statereporting l = on
l = off
State reporting value desired.
current poweroverride l on
l off
Power override forces the projector to remain in
the ON state when the command is received.
This command is NOT persistent and does not
get stored to non-volatile memory (cleared on
power cycle).
When this mode is enabled, the power button on
the remote and the ECP must not turn off the
projector.
This command must also be added to the
service menu so the user can disable it via the
OSD.
target poweroverride l = on
l = off
Value to set the power override to.