User manual
Table Of Contents
- Contents
- Important information
- Chapter 1: About your interactive whiteboard system
- Chapter 2: Installing your interactive whiteboard system
- Chapter 3: Using your interactive whiteboard system
- Appendix 4: Integrating other devices
- Chapter 5: Maintaining your interactive whiteboard system
- Chapter 6: Troubleshooting your interactive whiteboard system
- Before you start
- Determining your interactive whiteboard system’s status
- Resolving interactive whiteboard issues
- Resolving projector issues
- Resolving ECP issues
- Accessing the service menu
- Transporting your interactive whiteboard system
- Appendix A: Remotely managing your system through a network interface
- Appendix B: Remotely managing your system through an RS-232 serial interface
- Connecting your room control system to the ECP
- Projector programming commands
- Appendix C: Remote control code definitions
- Appendix D: Hardware environmental compliance
- Index
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
90 smarttech.com/kb/170401
Service Information
These are commands used in servicing and manufacturing of the unit. They should be hidden from the
user during normal operation.
Command/response definitions
Command Response Powered off
get displayhour displayhour =[current] no
set testpattern [target] testpattern =[current] no
set colorwheelidx
[target]
colorwheelidx =
[current]
no
get colorwheelidx colorwheelidx =
[current]
no
get failurelog failurelog =[current] yes
get error# Error#=[current] yes
set factoryreset [target] factoryreset =[current] yes
set highspeedfan
[target]
highspeedfan =
[current]
no
get highspeedfan highspeedfan =
[current]
no
set statereporting
[target]
statereporting =
[current]
yes
get statereporting statereporting =
[current]
yes
get poweroverride poweroverride=
[current]
no
set poweroverride
[target]
poweroverride=
[current]
no