User Manual

Warning:
The module is limited to OEM installation ONLY
The antenna installation must be professional installation, and does not permit use of any
antenna with the transmitter; the permitted types of antenna must be specified.
The module cannot be sold via retail to the general public or by mail order; it must be sold to
authorized dealers or installers only.
The end product intended use is not for consumers and general public; rather device is generally
for industrial/commercial use.
The installation shall be performed by trained licensed professionals, it uses specialized software
and adjusts the best angles and orientations, which are difficult for ordinary people to do.
The module is limited to installation in mobile or fixed application.
The OEM integrator is responsible for ensuring the end-user has no manual instruction to
remove or install module;
Modular approval allows installation in different end-use products by an original equipment
manufacturer (OEM) with limited or no additional testing or equipment authorization for the
transmitter function provided by the IDNMOD1. Specifically:
• No additional transmitter compliance testing is required if the module is operated with
the antenna listed in the document below.
• No additional transmitter-compliance testing is required if the module is operated with
the same general type of antenna (i.e. near-field segmented loop, circularly polarized
patches) as those listed in this User’s Guide and in the FCC filing for the IDNMOD1.
Acceptable antennas must be of equal or less far field gain than the antenna previously
authorized under the same FCC ID, and must have similar in band and out of band
characteristics.
In addition, the end product must comply with all applicable FCC equipment authorizations,
regulations, requirements and equipment functions not associated with the IDNMOD1. For
example, compliance must be demonstrated to regulations for other transmitter components
within the host product, to requirements for unintentional radiators (Part 15B), and to
additional authorization requirements for the non-transmitter functions.
The OEM applying the IDNMOD1 is required to include all FCC and/or IC statements and
warnings detailed in the following sections to the end product labeling (where specified) and
in the finished product manual. The OEM must also strictly adhere to antenna and
installation guidelines and MPE restrictions stated in this document.
The finished product manual must contain the following statement:
The host product shall use physical label stating "contains trnasmitter module
FCC ID: QCI-IDNMOD1" or "contains FCC ID: QCI-IDNMOD1"
IC: 4302A-IDNMOD1" or "contains IC: 4302A-IDNMOD1"