User Manual

ManualsBrandsSMART Technologies ManualsEnvironmental SensorSMART Technologies SRSM.ENV-SENSOR.01 Multi-Function Environmental Sensor

SRSM.ENV_SENSOR.01 Manual

FCC ID: QCI-IDNMOD1

IC: 4302A-IDNMOD1

1. Connector definition

PIN Number

Name

Description

3V OUT

3.3V voltage output by the module

USB DP

USB signal

GND

Ground

USB DM

USB signal

MCU INT

Reserved

I2C SDA

Reserved

I2C SCL

Reserved

GND

Ground

UART TX

Reserved

UART RX

Reserved

5VM

5V power supply

5VM

5V power supply

2. Antenna Area

The sensing area of the antenna is shown in the figure below:

host device brand name:86"LCD Monitor

hoset device model:IDX86-4

Summary of content (6 pages)

PAGE 1
SRSM.ENV_SENSOR.01 Manual FCC ID: QCI-IDNMOD1 IC: 4302A-IDNMOD1 1. Connector definition PIN Number 1 2 3 4 5 6 7 8 9 10 11 12 Name 3V OUT USB DP GND USB DM MCU INT I2C SDA I2C SCL GND UART TX UART RX 5VM 5VM host device brand name:86"LCD Monitor hoset device model:IDX86-4 Description 3.3V voltage output by the module USB signal Ground USB signal Reserved Reserved Reserved Ground Reserved Reserved 5V power supply 5V power supply 2.
PAGE 2
3. Instructions After the USB2.0 host is connected to this module, NFC-related functions can be operated through the USB CCID interface. 4.
PAGE 3
FCC warning: Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
PAGE 4
Warning: The module is limited to OEM installation ONLY The antenna installation must be professional installation, and does not permit use of any antenna with the transmitter; the permitted types of antenna must be specified. The module cannot be sold via retail to the general public or by mail order; it must be sold to authorized dealers or installers only. The end product intended use is not for consumers and general public; rather device is generally for industrial/commercial use.
PAGE 5
WARNING: The Federal Communications Commission warns that changes or modifications of the radio module within this device not expressly approved by SMART Technologies ULC. could void the user’s authority to operate the equipment.
PAGE 6
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including any interference that may cause undesired operation.