Maintenance Guide

C H A P T E R 3
Configuring your room system’s software
21 smarttech.com/kb/170450
d. Orient the interactive flat panel following the on-screen instructions.
N O T E S
o
If you touch a target in either the calibration screen or the orientation screen but
aren’t advanced to the next target, press the spacebar or the Orient button to
move to the next interactive flat panel and try again.
o
You don’t need to calibrate or orient the console.
4. Continue to the next procedure.
To optimize the camera and complete the software configuration
1. If SMARTSettings isn’t open from the previous procedure, click OEM Settings, and then click
SMART Board Settings.
SMARTSettings appears.
2. Click SMARTHardware Settings.
3. Click the camera icon, and then select Hardware Info & Settings from the drop-down list.
4. Click Preview.
The SMART Camera window opens.
5. Set the pan, tilt and zoom as appropriate for the meeting room’s size, select the mains power line
frequency for your country (50 Hz or 60 Hz), and then click OK.
N O T E
Digital pan and tilt options are available only when the camera is zoomed in.
6. Click OK.
SMARTSettings closes.
7. Continue to the next procedure.
Making a test call
To make a test call
1. Click Lync Settings, and then click Make a Test Call.
Lync Room System software makes a test call.
2. If the audio is too loud or too quiet, adjust the audio settings in the Lync Settings tab.