Maintenance Guide

C H A P T E R 3
Configuring your room system’s software
17 smarttech.com/kb/170450
5. Configure the displays as follows:
ConsoleLeft interactive flat panel Right interactive flat panel
(large rooms only)
1366 × 768
1920 × 1080 (1080p)1920 × 1080 (1080p)
I M P O R T A N T
o
Align the top of all displays as shown in the above diagram.
o
Set the console as the main display by clicking its thumbnail and then selecting
Makethismy main display.
o
Position the console to the right of the interactive flat panels as shown in the above
diagram.
o
You are unable to change these settings later, so ensure you configure the displays
correctly.
T I P
To determine which display is which, press Identify. Each display’s number appears briefly on
the display.
6. Click OK in Control Panel, and then click OK in second dialog box.
The Lync appliance checks the display configuration:
o
If there are major errors, a dialog box appears. Repeat this procedure to correct the errors.
o
If there are no major errors, Lync Room System software starts. Continue to the next
procedure.
Configuring Lync Room System software
N O T E
The following procedure documents SMART’s recommended configuration of Lync Room System
software for a typical Lync infrastructure setup. Refer to the MicrosoftLync Room System
Deployment Guide (microsoft.com/en-us/download/confirmation.aspx?id=39274) for detailed
deployment information.