Maintenance Guide

C H A P T E R 3
Configuring your room system’s software
14 smarttech.com/kb/170450
3. Configure the interactive flat panels’ on-screen display menus:
Room Procedure
Small (without
the table
microphone
upgrade kit)
a.
Press MENU on the interactive flat panel’s remote control.
b.
Press the down arrow until you select the SETUP menu, and then
press SET.
c.
Press the down arrow until you select Lync®ROOMRESET, and
then press SET.
d.
Press MENU, press the up arrow until you select the AUDIO menu,
and the press SET.
e.
Press the down arrow until you select AUDIOINPUT, press SET and
then select HDMI3/PC ANALOG.
f.
Press MENU until the on-screen display menu closes.
Small (with the
table microphone
upgrade kit)
a.
Press MENU on the left interactive flat panel’s remote control.
b.
Press the down arrow until you select the SETUP menu, and then
press SET.
c.
Press the down arrow until you select Lync®ROOMRESET, and
then press SET.
d.
Press MENU until the on-screen display menu closes.
Medium
a.
Press MENU on the interactive flat panel’s remote control.
b.
Press the down arrow until you select the OPTION menu, and then
press OK.
c.
Press the down arrow until you select Lync®RoomReset, and then
press OK.
d.
Press MENU until the on-screen display menu closes.
Large
a.
Press MENU on the left interactive flat panel’s remote control.
b.
Press the down arrow until you select the SETUP menu, and then
press SET.
c.
Press the down arrow until you select Lync®ROOMRESET, and
then press SET.
d.
Press MENU until the on-screen display menu closes.
e.
Repeat steps a to d for the right interactive flat panel.
N O T E
Completing the above steps configures the interactive flat panels’ USB-video mapping, audio
settings, presence detection settings and other settings for use with SMARTRoomSystems.
In addition, completing the above steps disables the volume and input select controls on the
interactive flat panels’ front control panels.
4. Continue to the next procedure.