User Manual
Table Of Contents
- Important information
- Chapter 1: About the SMART Response system
- Chapter 2: Getting started
- Using your SMART Response system
- Environmental requirements
- Computer requirements
- Connecting hardware and activating SMART Response software
- Activating SMART Response software
- Selecting how students answer questions
- Starting SMART Response LE software the first time
- Asking instant questions
- Setting up Teacher Tools
- Creating a class list
- Editing a class list
- Chapter 3: Using SMART Response software
- About SMART Notebook software
- Creating assessments
- Adding questions to the assessment
- About question types
- Adding questions using the Insert Question wizard
- About intelligent expression grading
- Creating answer keys
- Importing questions from a Word document
- Example Word document question formats
- Importing questions from an XML or SQZ file
- Importing questions from a PDF file
- PDF document formatting
- Importing questions from ExamView HTML
- Exporting ExamView tests
- About ExamView HTML question importing
- Setting answers for imported questions
- Adding choices to a question
- Tagging questions
- Starting and connecting to a class
- Connecting to the class
- Disconnecting students from a class
- Using clickers
- Completing assessments
- Chapter 4: Reviewing, printing and exporting assessment results
- Chapter 5: Maintaining your SMART Response system
- Appendix A: Hardware environmental compliance
- Waste Electrical and Electronic Equipment Regulations (WEEE directive)
- Restriction of Certain Hazardous Substances (RoHS directive)
- Batteries
- Packaging
- Covered electronic devices
- China’s Electronic Information Products regulations
- U.S. Consumer Product Safety Improvement Act
- California Air Resources Board – Airborne Toxic Control Measure
- Restriction of Certain Chemicals (REACH directive)
Clicker button Description
Ask Question Displays the clicker ID.
Menu Press with the Power button to open the clicker menu in Teacher mode.
See Using the Teacher mode menu below.
Answer Five colored buttons with geometric shapes to answer questions.
Using the Teacher mode menu
g To put SMART Response LE clickers into Teacher mode
Press the Power and Home buttons simultaneously.
N N O T E
You can press the Home button by itself without any effect.
Press the Enter button to make your selections. Press the Home button to return to the primary
menu.
The following options are available in the Teacher mode menu:
Option Description
Scan & Pick Pair the clicker with your receiver during setup.
Show Rcv PID Display the current Pan ID.
Clicker ID Set the Clicker ID.
Contrast Lightens or darkens the clicker’s LCD display. Use the up
and down arrows to increase or decrease the contrast.
Device Info Display the clicker’s MAC address and firmware version.
Restore Default Restore the clicker’s factory default settings.
Exit Exit Teacher mode to connect to the class.
C H A P T E R 3
Using SMARTResponse software
79