User Manual
Table Of Contents
- Important information
- Chapter 1: About the SMART Response system
- Chapter 2: Getting started
- Using your SMART Response system
- Environmental requirements
- Computer requirements
- Connecting hardware and activating SMART Response software
- Activating SMART Response software
- Selecting how students answer questions
- Starting SMART Response LE software the first time
- Asking instant questions
- Setting up Teacher Tools
- Creating a class list
- Editing a class list
- Chapter 3: Using SMART Response software
- About SMART Notebook software
- Creating assessments
- Adding questions to the assessment
- About question types
- Adding questions using the Insert Question wizard
- About intelligent expression grading
- Creating answer keys
- Importing questions from a Word document
- Example Word document question formats
- Importing questions from an XML or SQZ file
- Importing questions from a PDF file
- PDF document formatting
- Importing questions from ExamView HTML
- Exporting ExamView tests
- About ExamView HTML question importing
- Setting answers for imported questions
- Adding choices to a question
- Tagging questions
- Starting and connecting to a class
- Connecting to the class
- Disconnecting students from a class
- Using clickers
- Completing assessments
- Chapter 4: Reviewing, printing and exporting assessment results
- Chapter 5: Maintaining your SMART Response system
- Appendix A: Hardware environmental compliance
- Waste Electrical and Electronic Equipment Regulations (WEEE directive)
- Restriction of Certain Hazardous Substances (RoHS directive)
- Batteries
- Packaging
- Covered electronic devices
- China’s Electronic Information Products regulations
- U.S. Consumer Product Safety Improvement Act
- California Air Resources Board – Airborne Toxic Control Measure
- Restriction of Certain Chemicals (REACH directive)
Disconnecting students from a class
You can disconnect students from a class in three ways. You can disconnect them simultaneously.
disconnect individual clickers using Teacher Tools or have your students manually disconnect their
clickers.
Disconnecting all students
You can disconnect all students simultaneously.
g To disconnect all students by stopping the class
Select Response > Stop Class in the SMARTNotebook menu bar.
l All clicker-connected students disconnect, and a message appears on their clickers indicating
that the class is over and that the clickers are turning off. The Transmit and Receive lights on
the receiver turn off and the Ready light turns red.
l All SMARTNotebookSE software-connected students disconnect from the class, and a
message appears stating “All students are signed out”.
Disconnecting individual clickers using Teacher Tools
N N O T E
This option is available only if the students are connected to a class in Sign In mode.
g To disconnect individual clickers using Teacher Tools
1. Start Teacher Tools. See Starting Teacher Tools on page 23.
2. Select the active class in the Gradebook area.
3. Click the Students tab.
4. Select the row of the student you want to disconnect.
The Properties window appears below the student list table.
5.
Click Disconnect Clicker at the top-right corner of the window.
The Log Off Student dialog box appears.
C H A P T E R 3
Using SMARTResponse software
71