User's Manual
Table Of Contents
- Important information
- About SMART Response
- Installing SMART Response
- Getting started
- Using SMART Response
- About SMART Notebook
- Creating Assessments
- Adding questions to the assessment
- About question types
- About intelligent expression grading
- Adding questions using the Insert Question wizard
- Importing questions from a Word document
- Example Word document question formats
- Importing questions from an XML or SQZ file
- Importing questions from a PDF file
- Adding choices to a question
- Tagging questions
- Starting and connecting to a class
- Disconnecting students from a class
- Using clickers
- Completing assessments
- Reviewing, printing and exporting assessment results
- Maintaining SMART Response
- Hardware environmental compliance
- Waste Electrical and Electronic Equipment Regulations (WEEE directive)
- Restriction of Certain Hazardous Substances (RoHS directive)
- Batteries
- Packaging
- Covered Electronics Devices
- China’s Electronic Information Products regulations
- U.S. Consumer Product Safety Improvement Act
- California Air Resource Board – Airborne Toxic Control Measure
- Restriction of Certain Chemicals (REACH directive)
- Customer support
8
Water and fluid resistance
SMART Response’s components are for indoor use only and don’t meet any salt-spray
or water-ingress requirements. Don’t pour or spray any liquids directly onto SMART
Response components. These liquids could get into areas where they could damage
sensitive electronic components.
Dust and Scratching
SMART Response components are for use in office and classroom environments, and
aren’t for industrial use where heavy dust and pollutants can cause malfunctions or
impaired operation. They’re designed for pollution degree 1 (P1) as per EN61558-1,
which is defined as “No pollution or only dry non-conductive pollution.”
Electrostatic discharge (ESD)
SMART Response components meet the requirements of EN61000-4-2 severity level 4
for direct and indirect ESD. No malfunction or damage up to 15 kV (both polarities) with a
330 ohm, 150 pF probe (air discharge). Unmated connectors meet 8 kV for direct
(contact) discharge.
Conducted and radiated emissions
SMART Response hardware’s narrowband radiated electric field meets the limits for
Class B performance, as defined in EN55022/CISPR 22.
Computer requirements
Windows operating systems
l Pentium III 750 MHz or later processor
l 512 MB of RAM (1 GB recommended)
l 750 MB of free hard disk space for minimum installation (2150 MB for full
installation with Gallery collections)
l Windows XP, Windows Vista or Windows 7 operating system
l Internet Explorer Internet browser 6.0 or later
l Adobe Flash Player 10 or later
l Adobe Reader 8.0 or later
| C H A P T E R 2 – I N S T A L L I N G S M A R T R E S P O N S E