Laptop User Manual
Table Of Contents
- Important Information
- About the SMART Hub PE260
- Configuring the SMART Hub PE260
- Before Configuring the SMART Hub PE260
- Getting Started
- Understanding User and Configuration Modes
- Using the SMART Configuration Tools
- Entering the Activation Key for Multiple Projectors and Displays
- Configuring the Projectors and Displays
- Configuring the SMART Interactive Products
- Configuring the Display Controller
- Configuring Networking Features
- Setting the Date and Time
- Installing Printers
- Switching to User Mode
- Updating the SMART Hub PE260’s Software
- Troubleshooting
- Regulatory Compliance
- Customer Support
99-00898-20 REV B0 Configuring the SMART Hub PE260 15
3. Double-press Add Printer.
The Add Printer wizard appears.
4. Follow the instructions in the wizard to install the printer.
Switching to User Mode
After completing all procedures in this chapter, switch from Configuration mode to User mode
so that your organization’s users can begin using the SMART Hub PE260.
1. Press Home to open the Welcome Center and then press Exit Configuration Mode.
OR
In the SMART Configuration Tools dialog box, press Exit Config Mode.
A warning message appears, stating that your SMART Hub must restart to enter
User mode.
2. Press Yes.
Your SMART Hub restarts, and the Welcome Center appears.
To switch to User mode