User manual

A P P E N D I X A
Using the interactive flat panel on-screen display menu
56
Option Values Function Notes (if any)
MONITOR ID 1–100 Sets the interactive flat panel’s ID This option isn’t applicable to the
SMARTRoomSystem. Don’t
change it from its default value.
PROXIMITY CONTROL
PROXIMITY ENABLE
DISABLE
Enables or disables presence
detection
You can modify this option only if
you select STANDBY in
STANDBYMODE.
RE-ENABLETIME 1–10 Sets how long the interactive flat
panel waits before detecting
motion again (in minutes)
You can modify this option only if
you select ENABLE in
PROXIMITY.
AUTOPOWEROFF 15–240 Sets when the interactive flat
panel automatically turns off (in
minutes)
You can modify this option only if
you select ENABLE in
PROXIMITY.
BRIGHTNESS 0–100 Sets the brightness of the
welcome screen
This option isn’t applicable to the
SMARTRoomSystem. Don’t
change it from its default value.
CEC ENABLE
DISABLE
Enables or disables Consumer
Electronics Control (CEC)
support on HDMI inputs
This option isn’t applicable to the
SMARTRoomSystem. Don’t
change it from its default value.
HEAT STATUS
FAN1 [N/A] Shows the status of the first fan This option only provides
information. You’re unable to
modify it.
FAN2 [N/A] Shows the status of the second
fan
This option only provides
information. You’re unable to
modify it.
SENSOR1 [N/A] Shows the temperature reading
from the first sensor
This option only provides
information. You’re unable to
modify it.
SENSOR2 [N/A] Shows the temperature reading
from the second sensor
This option only provides
information. You’re unable to
modify it.
FAN CONTROL
COOLING FAN ON
AUTO
Sets the fan to run continuously
(ON) or only when the sensor
temperature is greater than
optimal sensor temperature
(AUTO)
FAN SPEED LOW
HIGH
Sets the speed of the fan
SENSOR1 35–55 Sets the optimal temperatures
for the first sensor (in degrees
Celsius)
SENSOR2 35–55 Sets the optimal temperatures
for the second sensor (in
degrees Celsius)