Maintenance Guide
Table Of Contents
- Cover
- Important information
- Contents
- Chapter 1 Welcome
- Chapter 2 Installing the display
- Chapter 3 Connecting computers and other devices
Chapter 2 Installing the display
smarttech.com/kb/171555 30
To connect the display to power
Connect the supplied power
cable from the AC power inlet on the back of the display to a power
outlet.
55" and 65" models
75" models 86" models
Note
Refer to the display’s specifications for power requirements and power consumption information
(see
More information
on page17).
To turn on and set up the display for the first time
Important
Install the OPSPC module before you turn the display on.
Notes
l
Touch is not available right after waking up the display or turning it on. Wait a few seconds and
then the display will respond to touch.
l
If a USB drive is connected to the display’s service port, do not remove the USB drive. The USB
drive contains an important firmware update.