User manual

S M A R T  R O O M  S Y S T E M F O R M I C R O S O F T L Y N C
Software configuration guide
7 1022893 Rev 02
To start your large room system
1. Flick the power switch on the bottom of the right interactive flat
panel.
2.
Press the Input Select button on the right interactive flat panel’s
front control panel until the input source is HDMI3/PC.
3. Flick the power switch on the bottom of the left interactive flat panel.
4.
Press the Input Select button on the left interactive flat panel’s
front control panel until the input source is HDMI3/PC.
The Lync appliance begins the first-run installation process. During this process, the Lync
appliance restarts several times.
N O T E
This process takes time to complete. During this process, displays might not change content
or might appear blank for several minutes.
5. Press MENU on the left interactive flat panel’s remote control.
6. Press the down arrow until you select the SETUP menu, and then press SET.
7. Press the down arrow until you select Lync®ROOMRESET, and then press the right arrow.
The on-screen display menu blinks briefly.
8. Press MENU or EXIT until the on-screen display menu closes.