User manual

S M A R T  R O O M  S Y S T E M F O R M I C R O S O F T L Y N C

Software configuration guide

4 1022893 Rev 02

5. Press the down arrow until you select USBSETTING, and then press the right arrow.

6. Press the left or right arrow until the USB1 option is set to HDMI1.

7. Press MENU or EXIT until the on-screen display menu closes.

8. Continue to Configuring Lync Room System software first-run installation settings on page 8.

To start your small room system

1. Flick the power switch on the bottom of the interactive flat panel.

Press the Input Select button on the interactive flat panel’s

front control panel until the input source is HDMI3/PC.

The Lync appliance begins the first-run installation process. During this process, the Lync

appliance restarts several times.

N O T E

This process takes time to complete. During this process, displays might not change content

or might appear blank for several minutes.

3. Press MENU on the interactive flat panel’s remote control.

4. Press the down arrow until you select the SETUP menu, and then press SET.

5. Press the down arrow until you select Lync®ROOMRESET, and then press the right arrow.

The on-screen display menu blinks briefly.

6. Press MENU or EXIT until the on-screen display menu closes.

N O T E

Completing steps 3 to 6 configures the interactive flat panel’s USB-video mapping, audio

settings, presence detection settings and other settings for use with the

SMARTRoomSystem. In addition, completing the above steps disables the volume and input

select controls on the interactive flat panel’s front control panels.

7. Continue to Configuring Lync Room System software first-run installation settings on page 8.