User Guide
Table Of Contents
- Cover page
- Important information for your interactive flat panel
- Chapter 1: About your interactive flat panel
- Chapter 2: Installing your interactive flat panel
- Chapter 3: Connecting computers and peripheral devices
- Chapter 4: Installing SMART software
- Chapter 5: Using your interactive flat panel
- Turning on and turning off your interactive flat panel
- Understanding presence detection
- Using the infrared remote control
- Getting started with your SMART Board interactive flat panel
- Playing audio files on your interactive flat panel
- Using the USB receptacle
- Chapter 6: Using guest laptops with your interactive flat panel
- Chapter 7: Maintaining your interactive flat panel
- Updating your SMART software and firmware
- Calibrating your interactive flat panel
- Orienting your interactive flat panel
- Replacing a pen nib
- Cleaning the screen
- Cleaning the presence detection sensors
- Cleaning the camera windows and reflective tape
- Maintaining ventilation
- Preventing condensation
- Checking the interactive flat panel installation
- Removing your interactive flat panel
- Transporting your interactive flat panel
- Chapter 8: Troubleshooting for your interactive flat panel
- Appendix A: Adjusting video settings with the on-screen display menu
- Appendix B: Hardware environmental compliance
- Index
Using the USB receptacle
You can connect a USB drive or device to the USB A receptacle on the side terminal panel on your
interactive flat panel, and then access it from computer 1 connected to VGA 1 and USB1.
N O T E
To disable the USBAreceptacle on the side terminal panel, see Disabling the USB receptacle on
the side terminal panel on page 20.
g To use the USB receptacle
1. Press the VGA 1 button on the remote control.
Press the Input button on the front control panel until the input source is VGA1.
2. Connect a USB device to the USB receptacle.
3. Use computer 1 to access the content on your USBdevice.
C H A P T E R 5
Using your interactive flat panel
46