User Guide
Table Of Contents
- Cover page
- Important information for your interactive flat panel
- Chapter 1: About your interactive flat panel
- Chapter 2: Installing your interactive flat panel
- Chapter 3: Connecting computers and peripheral devices
- Chapter 4: Installing SMART software
- Chapter 5: Using your interactive flat panel
- Turning on and turning off your interactive flat panel
- Understanding presence detection
- Using the infrared remote control
- Getting started with your SMART Board interactive flat panel
- Playing audio files on your interactive flat panel
- Using the USB receptacle
- Chapter 6: Using guest laptops with your interactive flat panel
- Chapter 7: Maintaining your interactive flat panel
- Updating your SMART software and firmware
- Calibrating your interactive flat panel
- Orienting your interactive flat panel
- Replacing a pen nib
- Cleaning the screen
- Cleaning the presence detection sensors
- Cleaning the camera windows and reflective tape
- Maintaining ventilation
- Preventing condensation
- Checking the interactive flat panel installation
- Removing your interactive flat panel
- Transporting your interactive flat panel
- Chapter 8: Troubleshooting for your interactive flat panel
- Appendix A: Adjusting video settings with the on-screen display menu
- Appendix B: Hardware environmental compliance
- Index
Connecting computers to your interactive flat
panel
You can connect up to three computers simultaneously to your interactive flat panel:
l Computer 1 (an installed room computer) connected to USB 1 and VGA1
l Computer 2 (a guest computer) connected to USB 2 and VGA2
l A guest laptop connected to USB 3 and HDMI 2 connector
N O T E
This document describes the default USB and video connections. To customize the USB and video
mapping, see Configuring the video and touch input for your SMART Board 8055i interactive flat
panel (smarttech.com/kb/170190).
C H A P T E R 3
Connecting computers and peripheral devices
16