User Guide
Table Of Contents
- Cover page
- Important information for your interactive flat panel
- Chapter 1: About your interactive flat panel
- Chapter 2: Installing your interactive flat panel
- Chapter 3: Connecting computers and peripheral devices
- Chapter 4: Installing SMART software
- Chapter 5: Using your interactive flat panel
- Turning on and turning off your interactive flat panel
- Understanding presence detection
- Using the infrared remote control
- Getting started with your SMART Board interactive flat panel
- Playing audio files on your interactive flat panel
- Using the USB receptacle
- Chapter 6: Using guest laptops with your interactive flat panel
- Chapter 7: Maintaining your interactive flat panel
- Updating your SMART software and firmware
- Calibrating your interactive flat panel
- Orienting your interactive flat panel
- Replacing a pen nib
- Cleaning the screen
- Cleaning the presence detection sensors
- Cleaning the camera windows and reflective tape
- Maintaining ventilation
- Preventing condensation
- Checking the interactive flat panel installation
- Removing your interactive flat panel
- Transporting your interactive flat panel
- Chapter 8: Troubleshooting for your interactive flat panel
- Appendix A: Adjusting video settings with the on-screen display menu
- Appendix B: Hardware environmental compliance
- Index
Connecting a room control system
You can control your interactive flat panel from a room control system.
g To connect your interactive flat panel to a room control system
Connect an RS-232 cable from the room control input on the inside terminal panel of the
interactive flat panel to the serial output on your computer or room control system.
I M P O R T A N T
Do not use a null modem cable. Use only a standard RS-232 cable.
For more information about setting up and programming a room control system, see Remotely
managing your SMARTBoard 8055i interactive flat panel (smarttech.com/kb/170189).
C H A P T E R 3
Connecting computers and peripheral devices
15