User Manual

These commands control the current system settings. These commands are available when the
projector is in Standby mode and when it is on.
Command Command target range Response
set restoredefaults [none] restoredefaults=done
set lamphrs [target] =0 lamphrs=0
set vgaoutnetenable [target] =on
=off
vgaoutnetenable=[target]
set usb1source [target] [Applicable only to interactive
whiteboard systems with ECPs]
[Applicable only to
interactive whiteboard
systems with ECPs]
set usb2source [target] [Applicable only to interactive
whiteboard systems with ECPs]
[Applicable only to
interactive whiteboard
systems with ECPs]
N  N O T E
The Network and VGAOut setting’s features are off by default. Select on to activate these
features.
A P P E N D I X B
Remotely managing your system through an RS-232 serial interface
70