User's Manual

9
Toggle 1, 2, 3, 4, 5, 6, 7, 8 to turn each zone in different mode
Indicates ALERT mode for a zone
Indicates ARM mode for a zone
Indicates the zone is turned OFF, number will not appear
- The LCD screen will display the below image:
A. Entering the HOME Mode
- First make sure the Smart Panel is in STANDBY Mode
- On the Smart Panel: Enter your 4-Digit PIN + “ENTER” then press to activate.
- On the Remote Control: Press to activate.
B. Triggers in HOME Mode
- Example: Zone setting:
Programming a Zone in each mode:
ZONE1 ZONE2 ZONE3 ZONE4 ZONE5 ZONE6 ZONE7 ZONE8
HOME
Mode
ALARM Disabled ALARM ALARM ALARM ALARM ALERT ALERT
(1234 /
4-DIGIT PIN)
+
4-DIGIT PIN
Enter 4-DIGIT
PIN for setting
Press then
to set the
Alert mode
Press to
complete the setting
“Standby”
Mode
1
2
3
4
Keys Description NoteStep
HOME mode default setting:
ZoneDevice
Status
(MODE)
WS102
WS102
WS103
Magnetic
Magnetic
PIR
1
2
8
ALERT
ALERT
ARM
Sensor
You must be in STANDBY Mode before any steps.
* To make sure you are in STANDBY Mode:
- Enter default PIN of 1 2 3 4 or your 4-Digit PIN
- Press ENTER
- The LCD screen will display the below image:
(One beep indicates that you entered a valid PIN;
Three beeps indicate that an invalid operation was performed).
- The LCD screen will display the below image:
(One beep indicates that you entered a valid PIN;
Three beeps indicate that an invalid operation was performed).
After setting is completed, the Smart Panel will return to
STANDBY Mode, ready for mode selection.