User's Manual

6
B. Disarming the System
- On the Smart Panel: Enter your 4-Digit PIN followed by to disarm the system.
- On the Remote Control: Press to disarm the system
C. Zone Settings
Programming a Zone in each mode:
You must be in STANDBY Mode
*To make sure you are in STANDBY mode:
- Enter the default PIN 1 2 3 4 OR your new 4-Digit PIN
- Press ENTER.
- The LCD screen will display the below image:
Entry delay: up to 15 seconds
* There is a 15sec entry delay time with a visual count down before the
system is armed.
* If the Zone is enabled a number will appear as displayed in the image
below:
(One beep indicates that you entered a valid PIN; Three beeps indicate
that an invalid operation was performed).
“Standby ” Mode
Step Keys Description Note
1
2
3
(1234 /
4-DIGIT
PIN) +
4-DIGIT
PIN
Enter 4-DIGIT PIN
and for ARM
Mode
Press
to Complete
The System will enter ARM Mode after 15 seconds.
You must be in STANDBY Mode
*To make sure you are in STANDBY mode:
- Enter the default PIN 1 2 3 4 OR your new 4-Digit PIN
- Press ENTER.
- The LCD screen will display the below image:
(One beep indicates that you entered a valid PIN; Three beeps indicate
that an invalid operation was performed).
“Standby ” Mode
Step Keys Description Note
1
(1234 /
4-DIGIT
PIN) +
ZONE1 ZONE2 ZONE3 ZONE4 ZONE5 ZONE6 ZONE7 ZONE8
ARM
Mode
ALARM ALARM ALARM ALARM ALARM ALARM ALARM ALARM