User's Manual

5
You must be in STANDBY Mode.
*To make sure you are in STANDBY mode:
- Enter the factory default PIN 1 2 3 4
- Press ENTER
- The symbol " " will disappear
Section 3 – Using the Wire-Free Home Protection System WS100S
3.1 Programming your new 4-Digit PIN
“Standby ” Mode
1
Entering the new PIN
Enter a 4-Dight PIN
* Choose from digits 0 to 9
Re-enter your 4-Dight PI
* One beep indicates that you entered a valid PIN; Three beeps indicate
that an invalid operation was performed.
Step Keys Description Note
1
2
3
4
1234
Enter
Setting the new PIN
4-Dight PIN
Enter
4-Dight PIN
Enter
Re-entering new PIN
for confirmation
Press then 1 to set the new PIN
The screen will show & symbols
3.2 Transmitting the Alarm Signal without a Siren
If you are forced to disarm the System, enter the Duress Password to stop the siren from sounding; the Smart Panel will silently
transmit the alarm signal to the optional sensors (Auto Dialer & Outdoor Bell Box) for help.
Duress Password:
Enter the default 4-Digit PIN = 1234+1
OR
Enter your personalized 4-digit PIN + 1
3.3 Operating different Modes
The system consists of 4 Operating Modes (STANDBY, ARM, ALERT, and HOME) to suit the user’s needs. You may select from
the 4 modes to be applied to the sensors.
3.3.1 STANDBY
If in Standby, the Smart Panel is prepared for mode selection.
3.3.2 ARM Mode
If in Arm Mode, the Smart Panel alarm will sound and a Red LED will flash when the system is triggered.
A. Arming the System
- On the Smart Panel: Enter your 4-Digit PIN + “ENTER” then press to activate.
- On the Remote Control: Press to activate.