User's Manual

“9VDC INPUT” port

Siren

Battery Compartment:

For AC Adaptor (Included)

120dB Buzzer

Backup battery - 9V Alkaline Battery (Not Included)

House code - Pin Header x 4, Jumper: x 4

“Reset” button - When you lost the 4-Digit, press: “Reset” and enter factory

default password

1.4 Introduction to the Smart Panel Backlight

Programming Buttons:

Other:

Function Buttons:

ARM HOME ALERT

Mode

ARM

HOME

ALERT

OFF

WS101 BZ Sound (Zone triggering)

Siren

Chime

No response

Backlight Indication

Triggered – Red backlight will flash

Triggered – Green backlight will flash

Operating – Yellow backlight ON

Section 2 – Installing the Wire-free Home Protection System WS100S

2.1 Installing the Smart Panel WS101

Determine the location of the Smart Panel:

Note:

- The panel should be placed within a few feet of an electrical outlet.

- The panel should be easily accessible.

- The panel should not be placed near doors or windows that could be accessed by unintended users.

- The panel should not be placed near extreme temperature sources (ovens, stoves etc.) or near large metal objects that could

interfere with the wireless performance.

Once you have selected a location for the Smart Panel, you are ready to begin powering up the System.

2.2 Powering up the Control Panel

Unscrew the battery compartment and remove the cover. Take out the LED demo socket and insert a new battery noting the

polarity as shown in the diagram below. Plug in the AC adaptor to the Smart Panel and connect it to a wall socket. Replace the

cover and the screw.