User's Manual

4.3 House Code and Zone Setting

The Wire-Free Home Protection System WS100S allows you can change the house security codes to avoid interference with

different combinations.

Step 1: Remove the battery compartment cover. You will find the 4 jumpers for setting the house security code. In most

cases you will not need to change the factory settings for the house security code. If the Smart Panel and sensors

activates intermittently or does not work at all, you may be able to solve the problem by changing your security code.

Step 2: Change the default settings of the Sensors

WS101

Jumper

WS101_TX

Dip-Switch

WS102

Jumper

WS103

Jumper

Smart Panel

House code: 1: closed, 2: closed, 3: closed, 4: closed

4-Button Key Fob Remote

House code: 1: closed, 2: closed, 3: closed, 4: closed

(To “ON” position)

Door/Window Magnetic Sensor

House code: 1: closed, 2: closed, 3: closed, 4: closed

Motion Sensor

House code: 1: closed, 2: closed, 3: closed, 4: closed

Zone Code

- Determinate the location of the Sensor in your home

- Pull out the Jumper and reassign it to the target zone

(zones 1 to 8)

- Replace and screw on the cover to complete the setting

change.