User's Manual

10
Section 4 – Installing the Sensors
4.1 Introduction to the Sensors
The Wire-Free Home Protection System WS100S allows you to expand your system at any time. The System includes a range
of sensors such as a 4-Button Key Fob Remote, a Door/Window Magnetic Sensor, a Motion Sensor, an Optional Auto Dialer,
an Outdoor Bell Box, a Mat Sensor, a Garage Door Sensor, an Inactivity Sensor, and a Shock Sensor.
The Wire-Free Home Protection System WS100S includes 3 wireless Sensors and 1 Key Fob Remote, which have a pre-
programmed default setting that begins working immediately once the battery is activated. It is advisable to install the main
package first and then personalize the settings once the System is functioning properly. This section should help you to
change the System settings in order to create a more personal home environment.
4.2 Installing the Sensors
First, determine the location of the sensors.
Note:
- The Sensors should not be easily accessible.
- The Sensors should be placed in the most vulnerable rooms or near key entry points.
- The Sensors should not be placed near extreme temperature sources (ovens, stoves etc.) or near large metal objects that
could interfere with the wireless performance.
Once you have selected a location for the Sensors, you are ready to begin powering up the System.
4.2.1 Installing the Door/Window Magnetic Sensor WS102
The wireless Magnetic Sensor consists of two pieces. The sensor detects when a door or a window is opened.
The two parts are fastened near the door or the window. One part functions as the transmitter and the other as the
magnet. Once the Magnetic Sensor is installed, any abnormality in the circuit will trigger an alert message that is
transmitted to the Smart Panel. The Magnetic Sensor is pre-programmed in Zone 1 and Zone 2; however, the settings
can be adjusted according to your needs. (See 2.4 Zone Setting)
A. Powering up the the Door/Window Magnetic Sensor WS102
- Remove the battery cover; insert new batteries noting the polarity as shown in the diagram below; replace the
cover. (Requires 2 - AAA batteries, Not Included)
B. Installing the Door/Window Magnetic Sensor WS102
- Mount the transmitter on a fixed surface such as a door or a window frame.
- Mount the magnet on a movable surface such as a door or a window.
- The transmitter side marked with a “> / < “ must face the magnet
WS102