User's Manual

6
Intercom Base Unit Installation
Remove the battery access cover using a small
phillips head screwdriver. Plug the rechargeable
Ni-Cad battery into the receptacle inside the
battery compartment. See diagram to the right.
When this is done, replace the battery access
cover.
Connecting the Battery
I
D
S
ET
Battery Plug
Battery
In order for the Intercom(s) to communicate with the Keypad the ID Codes must be set. If you are using more than one
Intercom, each intercom’s ID Code will have to be set separately.
IMPORTANT: Intercoms must be within 15 feet but no close than 9 feet during ID Code programming.
Batteries must be installed and the units turned ON.
1. Press the “ID SET” button on the Keypad until you
hear a beep, then release.
2. Press the “ID SET” button on the first Intercom for
approximately 2 seconds then release. You will hear
ONE beep from the Intercom and TWO from the
Keypad, which means the ID Codes are set.
NOTE: If you are installing more Intercoms at this time,
repeat Steps 1 and 2 for each Intercom you plan to use.
3. Test the system by pressing the CALL button on the
Keypad to see if the Intercom receives the signal.
2%,!9
/54054
!#$#
0/7%2).
        


o
*%4&5

o
o
o


o

3&4&5
+6.1&3
ID SET buttons
ID SE
T
VO
L
UM
E
POWER
O
FF
O
N
Keypad - Inside
Intercom - Bottom
Setting Intercom ID Codes