User's Manual

9
Test the System
IMPORTANT: The base unit and the keypad can not be within 30 feet of each other when operating. If units are
closer than 30 feet the signal will be inconsistent as well as emit speaker feed back.
Have someone press the CALL button on the keypad at the gate. When the base unit inside the house rings, press
the ANSWER button and talk to the person at the gate to check the connection and range. Then press the GRANT
PERMISSION button and have the person at the gate press any key on the keypad to activate the gate.
Trouble Shooting
Make sure all connections are secure and correct.
Other electronic devices in the same area may interfere with the factory ID code. If the system does not communicate
at all, reset the intercom/keypad ID code as follows.
RESET ID: This will require two (2) people.
1. Open the keypad and locate the “ID SET” button above the batteries.
2. Locate the “ID SET” button on the bottom of the intercom base unit.
3. Make sure the “antenna-to-antenna” distance between the keypad and the base unit is at least 30 feet.
4. Have one person press and hold the ID SET button on keypad for 5 seconds then release. The “CALLING” LED on
the keypad should turn ON. (If you here a long beep instead, repeat this step.) The keypad will stay in the “ID SET”
mode for 60 seconds.
5. Have the other person press and hold the “ID SET” button on the base unit for 5 seconds then release. The “PUSH
TO ANSWER/TALK” LED on the unit will turn ON.
6. Both units will beep three (3) times to indicate that they are now communicating and working properly.
7. If you don’t hear the 3 beeps. Move the units farther apart, wait 60 second and repeat the procedure.
If all connections are correct and the ID SET change didn’t solve the communication problem, please call our
Technical Service Department at 1-800-543-1236 Monday - Friday 8:00 am to 5:00 pm (ET).