Quick Start Guide

fusiontlc.com
Raven
10
fusiontlc.com
Raven
11
Connecting a Flash
Prepare Raven
In the Quick Settings Menu, tap the primary/
secondary brand selection button at the
bottom. Select your primary and secondary flash
brand from the list of available flash brands. If
you are only utilizing one flash brand, select
“None” for the secondary.
Select the zone(s) for which you want to utilize
a flash brand. Edit these zones to correspond to
the desired use (i.e. TTL, Multi-Pop, etc).
Advanced: select the channel you’d like to control
the flash with in the Quick Settings Menu by
selecting the primary brand channel button.
Prepare Flash
Place the flash in the same mode (TTL or Manual)
and zone as the zone on the Raven you’d like to
connect. If using PocketWizard, the remote must
be in TTL mode.
Test Connection
Press the Test button on the Raven to send a
test flash command to all active zones. If a flash
does not fire, confirm the following:
(1) Flash & Raven zones are the same and in
same control mode
(2) Flash is powered on and able to receive
control signals
(3) Flash is compatible with Raven. For
compatibity, see FusionTLC.com/compatability
or scan:
(4) Flash & Raven are updated to the latest