Installation & Assembly

Press the decorative Large Black Dome Caps

(L) over the heads of the 3/8” x 3” Hex Cap

Bolts. Then press the decorative Small Black

Dome Caps (M) over the heads of all exposed

#10 screws (J and K). You may need a small

amount of glue/epoxy depending on the cli-

mate. See Figure 9.

Attach the provided 3-Hook Towel Holder (I)

on the preferred side of your cover lift by simply

snapping it into place and inserting the middle

Self-Tapping Screw (L). See Figure 10.

Figure 9

How to OPEN your spa cover

1. Fold spa cover onto itself.

2. Lift the Lifter and spa cover to upright position by lifting at

the Foam Grip on the Support Arm (B), while supporting

the middle of the cover with the other hand. The Pivot Arm

will stop when it contacts the Mounting Bracket (E).

How to CLOSE your spa cover

1. With the spa cover in the upright position, hold the Foam

Grip on the Support Arm (B), and slowly guide the cover

and Lifter onto the spa shell. NEVER allow the spa cover to

fall onto the spa shell unassisted, as it can cause damage

to your Lifter, spa, and/or spa cover!

2. Unfold the spa cover off itself and engage the spa cover

locks if available.

CAUTION: DO NOT USE THE COVER LIFT IN HIGH WIND

CONDITIONS. DOING SO COULD CAUSE THE COVER

TO FALL. DAMAGE TO THE SPA/COVER/COVER LIFT,

OR INJURY TO THE OCCUPANTS MAY OCCUR. NEVER

LEAVE AN UNCOVERED HOT TUB OR SPA UNATTENDED.

Small Dome

Screw Cap

Large Dome

Screw Cap

How to Use

Figure 10