Installation & Assembly

Position the spa cover (in the closed position)
on the spa, making sure that all four corners
are properly positioned and square on the spa.
See Figure 1.
Before attaching the right & left Mounting
Brackets (G) to the appropriate side of the
spa, place the brackets where you will want
them positioned on the spa and mark the holes
with a marker. (SEE PRO TIP)
CAUTION: To prevent splitting a wood cabinet,
pre-drill holes with a 1/16” drill bit
Attach the Mounting Brackets (E) to the left
and right sides of the spa with the #10 x 1”
Mounting Screws. See Figure 2.
Connect the Pivot Arm (A) and two Bushings
(D) to the Mounting Brackets (E), using one
3/8” x 3“ Hex Cap Bolt (F), two 3/8” Flat
Washers (H), and one 3/8” Nylon Locknut
(G), as shown in Figure 3.
Note: If necessary, slide a 3/8” Wrench behind
the Mounting Bracket (E) to tighten the 3/8”
Nylon Locknut (G).
Repeat Step 4 for the other side of the spa.
After installing the Pivot Arms (A), tilt them
into the upright position. See Figure 4.
Figure 1
Figure 2
Figure 3
Figure 4
If you want 75% of the spa cover standing above spa
surface in the open position, place the Mounting
Brackets (G) 8” (20cm) down from the top of the spa
shell and approximately 9” (23cm) clearance behind
the spa will be needed.
If you want 50% of the spa cover standing above spa
surface in the open position, place the Mounting
Brackets 12” (30cm) down from the top of the spa
shell, approximately 15” (38cm) clearance behind the
spa will be needed.
1
PRO TIP
2
3
4
5
Installation Instructions