Installation & Assembly

ManualsBrandsSmart Spa ManualsHot Tub AccessoriesSpa Tub Top Mount Cover Lifter

INSTRUCTIONS

PARTS LIST

DESCRIPTION QTY

A. Pivot Arm 2

B. Cover Support Arm 2

C. Center Coupler 1

D. Bushing 4

E. Mounting Bracket 2

F. 3/8” x 3” Hex Cap Bolt 2

G. 3/8” Lock Nut 2

H. 3/8” Flat Washer 4

I. Towel Holder 1

J. #10 x 5/8” Self Tapping Screws 14

K. #10 x 1” Mounting Screws 20

L. Large Black Dome Caps 2

M. Small Black Dome Caps 38

7/16” Plug (Pre-Installed) 2

#10 x 1 3/4” Mounting Screw 4

Foam Grip (Pre-Installed) 2

Pivot Arm Cap (Pre-Installed) 2

Pivot Top Mount Hot Tub

Cover Lift

Tools Needed: Power/Cordless Drill with

phillips bit and a tape measure.

Summary of content (4 pages)

PAGE 1
Pivot Top Mount Hot Tub Cover Lift INSTRUCTIONS B. F. D. PARTS LIST DESCRIPTION A. Pivot Arm B. Cover Support Arm C. Center Coupler D. Bushing E. Mounting Bracket F. 3/8” x 3” Hex Cap Bolt G. 3/8” Lock Nut H. 3/8” Flat Washer I. Towel Holder J. #10 x 5/8” Self Tapping Screws K. #10 x 1” Mounting Screws L. Large Black Dome Caps M.
PAGE 2
Installation Instructions Figure 1 1 2 Position the spa cover (in the closed position) on the spa, making sure that all four corners are properly positioned and square on the spa. See Figure 1. Before attaching the right & left Mounting Brackets (G) to the appropriate side of the spa, place the brackets where you will want them positioned on the spa and mark the holes with a marker.
PAGE 3
6 7 8 Figure 5 Insert the long arms of the Support Arms (B) into the ends of the Center Coupler (C) as shown in Figure 5. Note: For narrow covers, flip the Support Arms (B) and insert the short side of the Support Arm (B) into the Center Coupler (C). Figure 6 Insert the short arms of the Support Arms (B) into the Pivot Arms (A). See Figure 6. Lay the Lifter on the spa cover, see Figure 7A.
PAGE 4
10 11 Press the decorative Large Black Dome Caps (L) over the heads of the 3/8” x 3” Hex Cap Bolts. Then press the decorative Small Black Dome Caps (M) over the heads of all exposed #10 screws (J and K). You may need a small amount of glue/epoxy depending on the climate. See Figure 9. Attach the provided 3-Hook Towel Holder (I) on the preferred side of your cover lift by simply snapping it into place and inserting the middle Self-Tapping Screw (L). See Figure 10.