Installation Guide

SET-UP AND ASSEMBLY
BEFORE BEGINNING ASSEMBLY,
CAREFULLY READ THE FOLLOWING
INFORMATION AND INSTRUCTIONS:
Place all parts in a cleared area and remove the
packing materials from the spa shell; do not dispose of
the packaging materials until assembly is completed
and the spa is in operation. Assembly requires two
people.
For help identifying the small parts used in assembly,
use the small parts list below or the Parts List on Page
5. Note: Some small parts may have been pre-attached
for shipping. If a part is not in the parts bag, check to
see if it has been pre-attached.
During assembly, make sure that all parts are oriented
as shown in the drawings.
Read each assembly step before you begin. Tighten all parts as
you assemble them, unless instructed to do otherwise.
ASSEMBLY REQUIRES THE FOLLOWING TOOL (not
included):
One (1) adjustable wrench
One (1) phillips screwdriver
One (1) hammer
One (1) power drill with a 1/16 drill bit and a 1/4 drill bit.
Soapy water
You will also need some silicone to apply to the screw heads
before installing the end caps. (optional)
SMALL PARTS LIST
Pivot Bolt
Metal Washer
Spacer Block
Mounting Brackets
Screw End Cap
Screw #2
Locknut
Corner Foam
Screw #1
1