Installation Guide

1. Lay out the components in the shape of a rectangle as shown below (Fig A). There are 2 sets of
Corner Pieces (A). They have been drilled so that the top left and bottom right are the same as are
the top right and bottom left. When assembling, position all Corner Pieces so that the pre-drilled
holes are FACING UP. NOTE: The LONG SIDE of the Corner Pieces goes Across the spa. The
SHORT side goes on each SIDE of the spa.
2. Side Mounting Blocks (D) over the LONG SIDE of each of the two bottom Corner Pieces
(A) as shown in Fig A. Remember, EACH CORNER PIECE MUST HAVE THE
PRE-DRILLED HOLES FACING UP.
Corner
Piece
Corner
Piece
Corner Piece (A)
Corner Piece (A)
Mounting Blocks (D)
BOTTOM
59” Bridge Arm
(C)
59” Bridge Arm
(C)
TOP
Pilot Holes
Face Up
Pilot Holes
Face Up
42” Side Arm (B)42” Side Arm (B)
Fig. A
3.Slide one of the 59” Bridge Arms (C) into each of the two Bottom Corner Pieces (A) as
shown in Fig A. Repeat the process for the Top Corner Pieces. You now have two assembled
pieces, the top and bottom sections.
4. Measure the maximum width of your spa. Slide the 2 Corner Pieces in on the each Bridge
Arm until the width matches the width of your spa cabinet plus 3”. Be sure to slide the Bridge
Arm an equal distance into each Corner Piece. Make sure Mounting Blocks are outboard of all
screws. With the assembled pieces laying at on a level surface, secure the Bridge Arms to the
4 Corner Pieces with the enclosed #10 x 5/8 self-drilling screws. Tighten all screws completely.
See Fig. B.