Installation Guide

USE OF THIS DEVISE WITH OLD, WATERLOGGERD COVER
MAY DAMAGE COVER AND LIFTER
NOTE: THERE MUST BE 18” CLEARANCE BEHIND THE SPA.
The Premium Cover Lifter adjusts to t most square/rectangular spas up to
99” in width. When assembled it forms a rectangular shape. The Premium
Cover Lifter attaches to the back of the spa cabinet, either on the back wall
of the cabinet or on the pedestal base. The Bridge Arm (C) lies across the spa
cover parallel to the seam (hinge) of the cover and is “captured” when the
cover is folded back over it. Once the cover is folded back, simply lift back
on the Side Arm and the Premium Cover Lifter will lift the cover off the spa
and hold it in an upright position behind the spa. Pilot holes are pre-drilled
in the Corner Pieces (A). Once sized to your spa, the self-tapping screws will
penetrate the Bridge Arms and Side Arms (B) to lock the tubing in place. Be-
fore assembling the Premium Cover Lifter, check the components in the box
against the Parts List to insure all parts are present. You will need a power/
cordless drill with Phillips bit and a tape measure.