Installation Guide

7. Mount the Mounting Blocks as wide and as low as possible. Attach the two Mounting
Blocks to the cabinet pedestal or base of spa cabinet it there is no pedestal, with the 1-1/4”
Wood Screws (G) provided. NOTE: Mounting Blocks may be attached directly to deck
surface or use Universal adaptor bracket available from your dealer for round, oval or
octagonal spas.
8. Pull out/Push in on the top Corner/Side Arm assembly to adjust the Cover Butler so that
the Bridge Arm is about 1/2” behind the fold seam of the spa cover as shown in Figure C. The
Bridge Arm must be parallel to the cover fold seam. Be sure to slide the Side Arms an equal
distance into each Corner Piece. Secure the Side Arms to each Corner Piece with #10 x 1-1/4”
screws. Use 3 screws per connection for all connections.
9. Center Cover Butler on spa so that there is approximately 1-1/2” clearance on each side be-
tween spa and the inside of Cover Butler tubing. Screw in one #10 x 5/8” self-drilling metal
screw just to the outside of each Mounting Block to lock Cover Butler into this position and
prevent it from moving side to side. See Figure B.
10. Insert one #10 x 5/8” self-drilling metal screw through the end of one Retaining Chain
(D). Fold spa cover back and lift cover with Cover Butler until cover is hanging vertically
behind spa. Attach Retaining Chain to OUTSIDE of Side Arm of Cover Butler approxi-
mately parallel with top of spa cabinet. Tighten screw securely but make sure that chain can
move freely on screw shaft. Attach the other end of the chain to the center hole in the Chain
Bracket (F) with a #10 x 5/8” self-drilling metal screw. With cover hanging vertically behind
spa with about 1” between spa cover and the back of the spa cabinet (Cover Butler will be in
a slightly over-vertical position), attach the Chain Bracket to the spa cabinet with three #8 x
5/8” wood screws. The Retaining Chain should be approximately parallel with the ground,
but this is NOT critical to operation. Tighten Screw securely, but make sure chain can move
freely on screw shaft. See Figure D.
18” clear-
ance behind
spa
Attach retaining chain to Cover Butler
and spa cabinet
INSTALLATION IS NOW COMPLETE