Installation Guide

USE OF THIS DEVISE WITH OLD, WATERLOGGERD COVER
MAY DAMAGE COVER AND LIFTER
NOTE: THERE MUST BE 18” CLEARANCE BEHIND THE SPA.
The Cover Butler adjusts to t most square/rectangular spas up to 99” in
width. When assembled it forms a rectangular shape. The Cover Butler
attaches to the back of the spa cabinet, either on the back wall of the cabinet
or on the pedestal base. The Bridge Arm (C) lies across the spa cover parallel
to the seam (hinge) of the cover and is “captured” when the cover is folded
back over it. Once the cover is folded back, simply lift back on the Side Arm
and the Cover Butler will lift the cover off the spa and hold it in an upright
position behind the spa. Pilot holes are pre-drilled in the Corner Pieces (A).
Once sized to your spa, the self-tapping screws will penetrate the Bridge
Arms and Side Arms (B) to lock the tubing in place. Before assembling
the Cover Butler, check the components in the box against the Parts List to
insure all parts are present. You will need a power/cordless drill with Phillips
bit and a tape measure.