Owner's manual

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 22 of 54
WARNING:
ever operate the system with the pump case drain plugged. Damage to the pump
ubricate hose fitting o-rings ONLY on the A.C. modular generator system with
Hose Installation Guidelines
N
seals will result. To do so will void the system’s warranty.
L
clean hydraulic fluid (Dexron III) before installation to prevent damage to them.
For A.C. LYModular Generator System ON !
ote:N See XRT manual for rescue system hose installation guidelines
ever install a hose without first flushing it with clean hydraulic fluid to remove any
ever install a hose in a location where it will rub against an abrasive surface or
o not position hoses with tight bend radii. Tight bends may kink and cause
n tightening the hose ends to prevent the hose from becoming
tall a 90° fitting at the pump outlet or inlet.
rm loops in the hose that may collect air or cause kinking. Run hose as
r the ends.
ses must have
resses applied to the hydraulic hoses.
o no put any substance into the reservoir other than clean, fresh Dexron III
N
debris.
N
sharp edge or corner.
D
serious damage to the system. Consult the hose manufacturer’s guidelines when
installing hoses.
se caution wheU
twisted.
ever insN
ever use an inlet line fitting less than 1”. N
ever install a hose tightly between connections. Leave length for the hoses toN
expand.
o not foD
straight as possible (but not taut) between connections.
o keep debris out of hoses while being positioned, coveT
o not bundle installed hoses tightly together with banding. HoD
freedom to expand.
o not operate the system with external stD
The A.C. modular hydraulic system generates hydraulic pressure approaching 5000
psi. A ruptured hose may result, causing personal injury or damage to the system.
D t
hydraulic fluid. Doing so will void the system’s warranty.