User guide

Smart Power
®
Systems
A. C. MODULAR GENERATOR SYSTEM
Page 49 of 53
The Pump Set option can be accessed by performing the following steps:
Step b: Hold Mode until
Amps Line 1 Blinks .
Release switch so 
appears.
Step c: Press mode twice
to make  appear.
Step d: After selecting
, Press On/Off until
 a
pp
ears.
Enabling pump set option
Figure 28
a. If the Command & Control Center is dark, press the Mode switch to put the
Command & Control Center into Normal mode.
b. Press and hold the Mode switch until the Amps Line 1 field blinks with  (more
than 10 seconds). Release the switch while the Amps Line 1 field is blinking to
make  appear. Reference Figure 28.
c. Press (and release) the Mode switch until  appears.
d. Press the On/Off switch until a  appears, indicating Pump Set option is Active.
e. Return to Normal mode by pressing the Mode switch until the screen shown in
Figure 29 is displayed. Pump Set will still be active.
Hours field alternates
between  and generator
status
(
 o
r

)
Actual Generator Output
Frequency
Example of normal display with Pump Set option set
Figure 29