Instructions / Assembly

Steps
Drawing
1. Select installation orientation:
horizontal or vertical
2. Using a level, draw a line for
installing the starter panel. Cut the starter
panel with a table saw. Avoid cutting steel
staples holding rubber on the back.
Remove staples if needed.
3. Use adhesive or fastening installation:
-
Fastening: use nails, staples, or
screws to fasten top and right side
rubber strips to the wall.
-
Adhesive: lightly apply a construction
adhesive to the back of the panels.
Overlap the next panel to the rubber
holders of the previous panel. Insert all
rubber holders behind planks.
-
Adjustment: adjust planks to match
with the previous panel and fasten
through the open area of backing
rubber holders on the top and right
side.
4. Overlap Panel # 2 to the rubber of the
top raw of Panel # 1. Place the bottom
rubber holders behind the top plank of
the bottom panel. Place the left rubber
holders behind the planks of the previous
panel.
Installation Steps
Holey Wood / Whole Wood / Barn Wood wall decor panels
1
2
3