User's Manual

Table Of Contents

11. Agency and Regulatory Body Approvals

Bluetooth product operating in 2.4GHz band for Home and Office use.

11.1. Exposure to Radio Frequency Radiation

The radiated output power of the BT RS232 DCE CLASS 2 and BT RS232 DTE CLASS 2 Bluetooth wireless radios

are far below the FCC, Industry Canada and European Union radio frequency exposure limits. Nevertheless, the

wireless radio shall be used in such a manner that the potential for human contact during normal operation is

minimized. The internal wireless radio operates within guidelines found in radio frequency safety standards and

recommendations which reflect the consensus of the scientific community.

The level of emitted energy emitted is far less than the electromagnetic energy emitted by wireless devices such as

mobile phones. However, the use of wireless radios may be restricted in some situations or environments, such as

aboard airplanes. If you are unsure of restrictions, you are encouraged to ask for authorization before turning on the

wireless radio.

The FCC, Industry Canada and European Union have set a general guideline of 20 cm (8 inches) separation

between the device and the body. This device should be used more than 20 cm (8 inches) from the body when

wireless devices are on.

11.2. FCC Part 15 Radio Frequency Interference Statement

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

• This device may not cause harmful interference.

• This device must accept any interference received, including interference that may cause undesired

operation.

Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference

in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not

installed and used in accordance with the instructions, may cause harmful interference to radio communications.

However, there is no guarantee that interference will not occur in a particular installation. If this equipment does

cause harmful interference to radio or television reception, which can be determined by turning the equipment off

and on. The user is encouraged to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and the receiver.

• Connect the equipment into an outlet that is on a circuit different from the receiver.

• Consult the dealer or an experienced radio/TV technician for help.

Pursuant to Part 15.21 of the FCC Rules for intentional or unintentional radiators, any changes

or modifications not expressly approved by the party responsible for compliance could void the user's

authority to operate this equipment.

Caution: