Operator's Manual

Copywrite 2019, Smart Forced Air, Inc. Page 4 of 8
System Linking
Your new Smart Forced Air Comfort System requires a small amount of setup to let the system know
which SFA Registers are associated with each Thermostat. The process to setup the system is as follows:
 Link the Thermostat to the Director module. Do this by entering Linking mode on the Director
and on each Thermostat
 Once the Thermostat is linked to the Director, enter Linking mode again on the Thermostat
 Then push the link button on the Register that you would like to associate with the Thermostat
 Repeat the process of linking the Thermostat with any additional Registers you would like
associated with that Thermostat
That’s it! Once each Thermostat is associated (Linked) to all the Registers for that zone, you can move
on to configuring the thermostats settings.
Thermostat Configuration
Hold Menu:
Enter this menu from the home screen by selecting the “HOLD” button. In this menu, you can cancel
hold mode (go back to the normal system program), enter temporary hold mode (the temperature will
be overridden until the next programmed time for a temperature change), or permanent hold (the
programmed temperatures are completely overridden).
Setting Temperatures:
To override the currently programmed temperature, press the up and down arrows on the home screen
to adjust the temperature up and down.
To setup the temperature program, enter the main menu and select “Edit Temperature Setting
Schedule.”
Next, select the days you would like to setup. You can setup individual days, or all days, all at once.
Once in the scheduling menu, simply scroll up and down to select the event you want to change, and
press the “Change” button. Adjust the time to where you would like it (Up and Down buttons), then
press “Next.”
Continue by adjusting the temperature set points. You can cancel out at any point, which will discard
any changes, or save the changes when you get to the end of the process by pressing the “Save” button.
When done making changes to the schedule, press the “Main Menu” button.
If you would like to make further changes to another day or group of days, simply go back into the same
“Edit Temperature Setting Schedule” menu, select the next day or group of days, and make your desired
changes.
System Mode: