Operator's Manual

Copywrite 2019, Smart Forced Air, Inc. Page 3 of 6

Welcome!

Thank you for your purchase of the Smart Forced Air Register product.

Introduction

The Register product is designed to allow the user to add climate control zones to their home or office.

Each Register can be associated (i.e. linked) to one SFA (Smart Forced Air) Thermostat. Multiple

Registers can be associated to one Thermosat.

Physical Installation

Verify that the size and type (floor, wall, or ceiling) of the SFA Register selected matches the size of the

Simply remove the existing register and replace it with the SFA Register. If the register is mounted in a

wall or on the ceiling, use the included screws to secure the register.

System Linking

Your new Smart Forced Air Comfort System requires a small amount of setup to let the system know

which SFA Registers are associated with each Thermostat. The process to setup the system is as follows:

 Ensure the Thermostat has already been linked to the Director.

 Once the Thermostat is linked to the Director, enter Linking mode on the Thermostat

 Then push the link button on the Register that you would like to associate with the Thermostat

 Repeat the process of linking the Thermostat with any additional Registers you would like

associated with that Thermostat

That’s it!

To ensure proper operation, it is a good idea to clean the Register with a vacuum and/or a dry rag every

year or so. In high traffic areas with lots of dust and dirt, you might find you like to clean more

frequently.

You will need to change the D cell battery in your Register every so often. The exact length of time

between changes will depend on your specific setup, how often the register vanes moves, how far they

move, etc. In general, we are hopeful you won’t need to do this more than once every few years. The

SFA System will give you alerts when this is necessary.