Installation Instructions

Page 3 of 4
190710
5
1. Once plugged into power supply, the Bluetooth Speakers will sound a remind music, and the speaker are enabled
and ready to connect.
2. Turn on/off light by using the pull chain.(Note:The speakers can continue working while the light is off. )
3. Enable Bluetooth on your smart device.
4. Wait for the smart device to detect the “shop light 1” and then select it to pair the device to the speakers. When
successfully paired, the speakers will indicate “Connected”.
5. Play music from your device while connected to the shop light to enjoy sound from the Bluetooth speakers.
6. Turn off music on your smart device, disconnect the shop light from Bluetooth on your smart device, or disable
Bluetooth functionality on your smart device when sound is not wanted from the shop light speakers.
NOTICE:
1. Bluetooth enabled smart devices typically have a range of approximately 33 ft. (10 m). Attempting to
pair your smart device to the Bluetooth speakers beyond the intended range can result in poor audio
quality, drop-outs, or failure to connect.
2. Only one device can be connected to the Bluetooth speakers at a time.
OPERATING THE SHOP LIGHT AND BLUETOOTH SPEAKERS:
CARE AND MAINTENANCE
Caution: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker off or
removing the fuse from the fuse box.
The following parts are available for re-order if damaged or missing. Call our toll free at 1-800-887-6326.
Spare Parts List:
BBAA
Mounting Chain With “S” Hook
3204CP
Additional Pull Chain
3039PU
TROUBLESHOOTING
The power is off.
The circuit breaker is off.
There is a bad connection.
There is a defective switch.
The fixture will not light.
Ensure the power supply is on.
Ensure the circuit breaker is in the on position.
Check to ensure proper wire connections are made.
Contact a qualified electrician.
Contact a qualified electrician.
The Bluetooth speakers will
not pair with a smart device.
The smart device is out of range of
the Bluetooth speakers.
The smart device is not
discoverable.
Bluetooth speaker reset.
Be sure the shop light is within 33 ft. (10 m) of the
smart device.
Turn on “Discoverable” mode on the device to allow
the shop light and smart device to recognize each
other.
Confirm the device’s “Discoverable” mode is turned
on to allow the shop light and smart device to
recognize each other.
The fixture will be in “Reset” mode after turning
power off and on again. In this case, please remove
“shop light 1” from the smart device paired list and
rediscover it. Then pair the bluetooth speaker with
smart device again.
Problem
Possible Cause
Solution