Installation Instructions

Fig.10
Troubleshooting
Page 5 / 6
Using linking cord to connect two more LED strip lighting fixtures:
Each additional fixture (not included) should be mounted in the same way as the previously installed fixture.
Once installed, attach the linking cord (12 inches) into the input receptacles between the previously installed
fixture and the additional fixture . (See Fig.10)
Make sure the distance between LED strip lighting fixtures does not exceed the linking cord length.
Care and Maintenance
Caution: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker
off or removing the fuse from the fuse box.
This LED light fixture is made from quality materials that will last many years with minimum care. You may
want to periodically clean the fixture with a soft cloth. To maintain the best appearance of the fixture, do
not use cleaners with chemicals, solvents or harsh abrasives. Do not use liquid cleaner on the LEDs, LED
drive, or wiring inside the light fixture.
Linking Cord (C)
Previously Installed Fixture
Additional Fixture
LED Strip Lighting Fixture
B. Using linking cord:
POSSIBLE CAUSE CORRECTIVE ACTION
The fixture will not light
The fuse blows or circuit
breaker tips when the light
is turn on.
The power is off.
Check to ensure the power
supply is on
Check to ensure the circuit
breaker is in the on position
Check to ensure proper wire
connections are made. Contact a
qualified electrician.
The circuit breaker is off.
There is a bad connection.
There is a defective switch.
The wires are crossed or the power
wire is grounding out.
Contact a qualified electrician.
Check to ensure proper wire
connections are made. Contact a
qualified electrician.
PROBLEM