Installation Instructions

Turn on the power at fuse or circuit box.
4. Attach the fixture plate to ceiling by inserting two dry wall screw heads into key hole slots, then slide the fixture
plate to left or right until the heads of the dry wall screw are located into narrow ends of the key hole slot. Finally
use a screwdriver (not included) to tighten the dry wall screws. (See Fig.1,3)
5. Attach two end caps back to fixture plate by securing four set screws. (See Fig.1,2)
Care and Maintenance
Caution: Before attempting to clean the fixture, disconnect the power to the fixture by turning the breaker
off or removing the fuse from the fuse box.
This LED light fixture is made from quality materials that will last many years with minimum care. You may
want to periodically clean the fixture with a soft cloth. To maintain the best appearance of the fixture, do
not use cleaners with chemicals, solvents or harsh abrasives. Do not use liquid cleaner on the LEDs, LED
drive, or wiring inside the light fixture.
Outlet Box
Wire Nut (C)
Fixture Wire
Anchor (A)
Dry Wall Screw (B)
PC Diffuser
PC Diffuser
Page 2 / 3
Fixture Plate
Set Screw
Set Screw
End Cap
Source Wire
Key hole slot
Dry Wall Screw
End Cap
Fixture Plate
Fig.1
Fig.3
Fig.2