Installation Instructions

Page 3 of 4
ASSEMBLY INSTRUCTIONS (continued)
A
2. Attach the fixture plate (A) to the location where you want to install, mark the target where is for two anchor (AA) to
secure fixture plate (A) to the ceiling. Remove the fixture plate (A) and drill two holes on the target. Hammer the
anchors (AA) to target holes tightly, and then secure the dry wall screws (BB) to anchors in part way.
2
3. Pull out the source wires from the outlet box. Make wire connections using wire connectors as follows:
---Connect the hot wire (usually black insulation) from the fixture to the black wire from the power source.
---Connect the neutral wire (usually white insulation) from the fixture to the white wire from the power source.
---Connect the fixture grounding wire (usually green insulation or bare wire) to the house grounding wire from the power
source.
Carefully put the wires back into the outlet box.
AA
BB
Ceiling
Outlet Box
Anchor
3
Outlet Box
Wire Connector (C)
Fixture Wire
Source Wire
Key hole slot
A
BB
4. Attach the fixture plate to ceiling by inserting two dry wall
screw (BB) heads into key hole slots, then slide the fixture
plate (A) to left or right until the heads of the dry wall
screw (BB) are located into narrow ends of the key hole slot.
Finally use a screwdriver (not included) to tighten the dry wall
screws (BB).
4
5
Set Screw
C
B
5. Attach two end caps (C) back to fixture plate by
securing four set screws.
Turn on the power at fuse or circuit box.